Finally, I got the finish issue resolved on my boomerang tables. The next hurdle to jump was attaching the hardware to the legs and table bottoms. And the (almost) final chapter was screwing the legs onto the body of the table. Here’s the table upside-down with the legs attached:2015-11-08 17.16.47

And here’s the table right side up with the tops in place. Houston, we have a problem.

Boomarang table

It’s a good thing I haven’t drilled pilot holes or attached these upper supports to the tier tops yet. These proportions are all wrong! Ten inch supports do not match the look or the feel of the original table. I will need to take them down to 6 inch supports instead.

Advertisements